So, again many thanks for the information and now I see the code symbol (actually its an html tag, but hey) and will use it in the future if necessary. Most forums that I participate in have a simple button that inserts the image at the cursor. That having been said, that procedure is a very complex way of getting pictures into at post. The breadboard icon for this part is just fine, but the schematic circuit model that I have shows only 10 pins ins… I have been search a long time for an. I have been search a long time for an upgraded corrected schematic circuit model for this Fritzing part. Had the photos uploaded to the site as attachment, but when I tried to actually insert them I received an error message so I haven't gone back to see what the issue might be. Corrections to L298N Dual H Bridge Fritzing part - parts help - fritzing forum.

As for the pictures, I did read the thread you pointed to. So I scanned these rules and completely missed the section on posting code. All the rules have basically been the same. But on my own behalf, I have been participating in forums since they were called bulletin boards and you accessed them with a dial-up line at 300 baud. I have more coding to do and I have to figure out the LCD (another thread) but at least the motor, the pot and the buttens are all running ok now.Īs for reading the rules, sorry, you caught me. I now have the bugs worked out and have it running on a bread board. I will need the ability to change speed using a pot and button, be able to reverse direction again using a button. As for voltage, I plan on running a 24 volt motor with this controller. Tom you were right, the common ground was the problem.

L298n h bridge fritzing model